Computer Aided-Design (CAD)
Computer-Aided-Design (CAD)
Step 1: set thickness as t1 and kerf as k1 in change parameters (image 2) under: modify> change parameters (image 1)
Image 1
Image 2
Step 2: create the sketch in image 3 below using the following instructions:
1. create a rectangle of size 170mm x 85mm and a rectangle of 95mm x 85mm
2. under modify> fillet, use fillet to click all 4 corners of both rectangles.
3. set fillets to 5
4. under create> rectangle> center rectangle, use center rectangle to create slots of
t1-k1 (fx; 4.90mm) x 84mm such that the size of the slot is t1-k1 x 42mm
5. under insert, insert design of any image (DXF/SVG) in my case, it is an image of a fox
Step 3: right-click, select extrude (shortcut is e), and extrude image by t1
your design should look like image 4 below
Image 4
Step 4: to laser cut, hide the body on the left (image 5), right-click sketch to save as DXF file to laser cut
Image 5
